Tandberg 800 Manuel d'utilisateur télécharger pdf

D12528, Rev 03

Guide for installation in a medical environment

Introduction

The intention of this document is to advise the reader of the additional unpacking and

installation instructions which must be carried out prior to the videoconference system being

ready for use in a medical environment.

This guide covers the following TANDBERG systems and must be used together with the user

manual for these systems:

•

TANDBERG 6000 (Dual or Single monitor)

•

TANDBERG 2500 (Dual or Single monitor)

•

TANDBERG 800 (Dual or Single monitor)

When connecting peripheral equipment, the user is responsible to obtain and keep

documentation showing that the assembled system complies with the relevant EU-directives.

System installation in a medical environment

When installing the videoconference system (TANDBERG 6000, TANDBERG 2500 or

TANDBERG 800) in a medical environment, the system must be supplied from mains through

the portable isolation transformer provided, manufactured by Toroid Corp of Maryland, type ISB-

060W or ISB-100W.

•

The isolation transformer must not be placed on floor level.

•

Only equipment forming a part of the videoconference system must be connected to the

isolation transformer. Connecting equipment forming parts of other systems may cause

hazardous leakage-current exceeding the requirements for Medical Equipment.

•

Do not connect any equipment or peripherals like VCRs, Document Cameras etc., which are

not supplied by the isolation transformer, to the videoconference system. This can cause

hazardous leakage-current, exceeding the requirements for medical equipment.

•

Equipment or peripherals connected to the isolation transformer must not have an input rating

in conflict with the output rating of the isolation transformer. This rating is: 115/230V, 50/60Hz,

600VA.

•

Multiple socket outlets or extension cords should not be connected to the isolation

transformer.

•

Use a moist cloth to clean the isolation transformer and the videoconference system

connected to it, if needed.

•

When the systems are installed according to the instructions above, in addition to the

regulations given in the installation section of the user manual for the TANDBERG 6000,

TANDBERG 2500 or TANDBERG 800, the videoconference system and isolation transformer

can be used in a patient environment

Safety Approvals

•

When installed according to the regulations given above, the videoconference system

(TANDBERG 6000, TANDBERG 2500 and TANDBERG 800), complies with the safety

standard for medical devices: IEC 60601-1-1

•

Note: The UL marks attached to the equipment refers to the approval according to UL 1950.

This approval is not valid when the equipment is installed in a medical environment.

This guide is for equipment installed in the EU/EEA-area only!

For systems installed outside this area additional approvals and precautions may be necessary.

D12528, Rev 03 1

Résumé du contenu

Page 1 - D12528, Rev 03

D12528, Rev 03 Guide for installation in a medical environment Introduction The intention of this document is to advise the reader of the addit

Modèles reliés 2500

Commentaires sur ces manuels

Pas de commentaire

Tandberg 800 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Moniteurs Tandberg 800. TANDBERG 800 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés 2500

Commentaires sur ces manuels

Produits connexes et manuels pour Moniteurs Tandberg 800