Tandberg MPS API Interface D13639 Manuel d'utilisateur télécharger pdf (Page 26)

TANDBERG MPS API

User Guide

<configuration-type root command> <address expr> ?/help

Example 2.7

User wants to configure IP:

xconfiguration ip ?

*h xConfiguration IP Assignment: <DHCP/Static>

*h xConfiguration IP Address: <IPAddr>

*h xConfiguration IP SubnetMask: <IPAddr>

*h xConfiguration IP Gateway: <IPAddr>

NOTE! Only typing xconfiguration ?, actually addresses all configuration elements within

the xconfiguration root command. One would therefore expect that help on all configurations

would be returned. But as described above, this is a special case and only listings of the top

level elements are returned. To get help on all configurations supported by the system, type:

xconfiguration // ?

xconfiguration ??

2.3.2 Configuration read

To read configurations, type the configuration-type root command followed by an address

expression:

<configuration-type root command> <address expr>

Example 2.8

User wants to read IP configurations:

xconfiguration ip

*c xConfiguration IP Assignment: Static

*c xConfiguration IP Address: "10.47.8.20"

*c xConfiguration IP SubnetMask: "255.255.248.0"

*c xConfiguration IP Gateway: "10.47.8.1"

2.3.3 Configuration set (write)

To set configurations, the address expression following the configuration-type root command

must end with a colon. The value to be set must be added after the colon:

<configuration-type root command> <address expr>: value

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 83 84

Pas de commentaire

Tandberg MPS API Interface D13639 Manuel d'utilisateur Page 26